Filter penghisap kembali Argo-Hytos seri E598, E998

Filter Return-Suction Argo-Hytos Series E598 and E998

Filter fineness: 10, 16 microns

Maximum flow rate: 850 l/min

Maximum pressure: 10 bar

Application: For use in mechanisms with hydraulic drives, in cases where the drain flow under any operating conditions is higher than the flow of the feed pump oil.

Operational characteristics: Wear protection: Thanks to the filtering elements, which, when fully filtered, comply with the highest cleanliness class standards.

Suction filter functions: Thanks to 100% filtration of the incoming flow, dirt does not penetrate inside the feed pump.

Drain filter functions: Thanks to full-flow filtration in the return system, pumps are protected from the ingress of dirt particles remaining in the system after installation or repair, or caused by wear or penetration from outside.

Filtering elements: Flow direction from outside to inside. Star-shaped pleating of the filter material provides: Large cleaning surface; low pressure drop; high dirt retention capacity; long service life.
Materials:

Screw-on cover: aluminum alloy

Filter head: aluminum alloy

Filter cup: steel

Seals: NBR (viton on request)

Filtering material: EXAPOR®MAX 2 - mesh of inorganic multilayer glass fiber
Paper - cellulose fabric impregnated with resin
Accessories:
Electrical and/or visual clogging indicators - optional with one or two switching points, temperature-independent.

Installation: Vertical with deviation up to 15°

Selection table