Filter return-suction Argo-Hytos seri E084

Filter Return-Suction Argo-Hytos Series E084

filtration fineness: 10, 16 microns

maximum flow rate: 80 l/min

maximum pressure: 10 bar

Application: For use in mechanisms with hydraulic drives, in cases where the drain flow under any operating conditions is higher than the flow of the feed pump oil.

Operating characteristics: Wear protection: Thanks to the filtering elements, which, when fully filtered, meet the highest cleanliness class standards.

Suction filter functions: Thanks to 100% filtration of the incoming flow, dirt does not penetrate into the feed pump.

Drain filter functions: Thanks to full-flow filtration in the return system, the pumps are protected from the entry of dirt particles remaining in the system after installation or repair, or caused by wear or penetration from outside.

Filter repair: The filter indicator signals the need for repair, thus ensuring the longest possible filter operation.

Filter elements: Flow direction from outside to center. The corrugated filtering surface provides: Large filtration area. Low pressure drop. High dirt holding capacity. Long service life. All settled dirt is completely removed from the filter element after extraction and does not enter the tank again.

Accessories: Electrical and optical contamination indicators.

Material: Screw cap: Polyamide, reinforced fiberglass

Filter head: Aluminum

Filter cup: Aluminum Seals: NBR (Viton-on request)

Filling: EXAPOR®MAX - mesh of inorganic multilayer microfibers

Installation: Standard without restrictions, vertically. Models with a safety suction valve can deviate by 15° vertically. Models with a 4 mm hole in the check valve can deviate by 45° vertically.

Selection table