Filter drain Argo-Hytos seri E441, E451, E461, E641 dan E700.

Filter drain Argo-Hytos series E441, E451, E461, E641 and E700

filtration fineness: 10, 16, 30 μm

maximum flow rate: 800 l/min

maximum pressure: 10 bar

Application: In high pressure return lines of hydraulic systems.

Wear protection: Using filter elements that even with full filtration meet the highest cleanliness class requirements.

Fault protection: By means of full-flow filtration in the system, pumps are primarily protected from dirt particles entering the system from the outside, remaining after assembly, repair, due to wear.

Special features:

Installation: Installation directly in a separate section of the oil return tank. This solution allows the use of multiple return lines and does not impose any restrictions with the help of the filter head.

Relief valve: Located near the inlet of the filter element to prevent contaminated particles from entering the clean side of the filter.

Removable bowl: In case of technical maintenance, the filter bowl is removed together with the filter element.

Filter elements: Flow direction from outside to inside. Star-shaped pleating of the filter material provides: Large cleaning surface; low pressure drop; High dirt holding capacity; Long service life.
Materials:
Filter bowl: Phosphated steel
Lower part of the housing: Polyamide, glass fiber reinforced, (for E 700: phosphated steel)
Seals: NBR (viton on request) 

Filter material: EXAPOR®MAX 2 - mesh of inorganic multi-layer glass fiber
Paper - cellulose fabric impregnated with resin

Accessories:
Extension tubes or diffusers at the outlet of the bowl are available on request. It is even possible to combine both options.
Extension tube: The correct length of the extension tube ensures an outlet below
the minimum oil level and prevents foaming.
Diffusers: reduce the speed of the oil and direct the oil at a 90 ° outlet flow.
This function also prevents oil foaming and swirling of solid particles at the bottom of the tank.

Selection table