Filter drain Argo-Hytos series E303, E503, dan E703.

Filter drain Argo-Hytos series E303, E503 and E703

filtration fineness: 5, 10, 16 μm

maximum flow rate: 900 l/min

maximum pressure: 10 bar

Application: In high-pressure return lines of hydraulic systems.

Wear protection: With filtering elements that even with full filtration meet the highest cleanliness class requirements.

Failure protection: Through full-flow filtration in the system, pumps are primarily protected from dirt particles entering the system from the outside, remaining after assembly, repair, due to wear.

Special features:

Relief valve: Located near the inlet of the filter element to prevent contaminated particles from entering the clean side of the filter.

Removable bowl: In case of technical maintenance, the filter bowl is removed together

with the filter element.

Filtering elements: Flow direction from outside to inside. Star-shaped pleating of the filter material ensures: Large cleaning surface; low pressure drop; high dirt-holding capacity; long service life.

Materials:

Screw-on lid: steel

Filter head: aluminum alloy

Filter cup: steel

Seals: NBR (viton on request)

Filter material: EXAPOR®MAX 2 - mesh of inorganic multi-layer glass fiber
Paper - cellulose fabric impregnated with resin.

Accessories:
Extension pipes and diffusers at the bowl outlet are available on request.
Extension pipe:
The correct length of the extension pipe ensures an outlet below the minimum oil level and prevents foaming.
Diffuser: Diffusers reduce the oil velocity and direct the oil at a 90 ° angle to the outlet flow.
This function also prevents oil foaming and the swirling of solid particles at the bottom of the tank.
Electrical and optical clogging indicators are available on request.

Selection table